710 Carbon Fiber Tent Poles
These Poles are designed for use in Tents and Tarps within the provided heights. These poles are typically
used in a lot of larger pyramid tents, and similar sized shelters.  These poles come standard with an adjuster
for variable pitch heights, with shock cord, and with or without a spike at the top for use with shelters that use

The 710 pole comes standard with an adjuster that provides ~8" of adjustment.

Pole heights with Adjuster:
You need to order your pole at the nominal height that your shelter pitches at. So if you have a shelter that
pitches at 75", you want to go with a pole that is 75" long. With the adjuster this will give you a pole that pitches
from ~71" to ~79".  

Adjuster construction: The main stem of the adjuster is our carbon fiber tube. The bottom has a cap to keep
dirt out.  The business end consists of a brass button on a spring inside the adjuster section. This brass
button corresponds to holes that are machined into the bottom section of the tent pole. This gives adjustment
in 1" increments.  This arrangement is the lightest possible solution for adjustment adding barely  .5oz over no
adjuster at all. Does this weaken the pole? No, not if built correctly, this is not where the bulk of the stress is
placed on the pole. We have built hundreds of these, and this has never been the failure point.  

Shock Cord
The 710 poles come standard with shock cord.

The 710 pole comes standard with a friendly plastic end cap on the top and bottom of the pole.  If your shelter
requires a spike(like some large tarp set ups) then you can order the pole with a spike to accommodate your
particular configuration.
75" to 68", 4 Section .710 Tent Pole--- A 75 Inch pole weighs 7.5oz, you
can subtract .066oz per Inch shorter than 75 Inches---$110---  

____In Stock____
67" to 61", 4 section .710 Tent Pole--- A 67 Inch poles weighs 6.95oz., you
can subtract .066oz per inch shorter than 67 inches ---$110---

____In  Stock____